top of page
- EAT series -
Hydraulic system finger joint machine
Hydraulic type high-speed finger joint system
Carriage move speed:22M/22M 3cycle/min
(Calculated by vertical/working size:23MMx50MM)
Standard maximum performance-78pcs/min
EAT series is the most classical standard hydraulic type. Since 1993, we keep improving this series. Nowadays, it is the third generation. Because the design of greater output pressure, stable driving and economical in cost, EAT is the main product of FURNIMATE for many years.
●= Standard / o(—) = Optional / - = No configuration / F = Fully automatic configuration / H = Configure the pre-joint system / B = Configure rear feeding conveyor system / C = Simple Conveyor Configuration / 2L = Double finger assembler configuration
Shaper’s machines body are more stable and parts standardization.
Linear slides change in the side of machine, strengthening the stability of the shaper’s move carriage.
Enhance the strength of hydraulic cylinder shaft.
Saw shaft tube holder to casting, the material is more stable, saw the axis of the material change using Japanese blue steel(Nickel Chromium Molybdenum Alloy Steel JIS G4103-1979), structural change and the same vertical finger spindle, and the drive belt was changed timing belt.
Roller conveyor system the roller diameter down to 60mm and increase strength, so that make the short material through more stable!
New model of glue applicator, the old system is using air pressure tank change to air cyclinder to squeeze out of glue. That has five times of pressure than air tank output.
Finger assembler, front section-in feed device has change to 5 sets of in-indde roller with independent cylinder and yaw press system.
Control methods change to HMI control panel.
No.62, Ln.549, Sec.2, Sanfeng Rd., Fengyuan Dist., Taichung City 42073 Taiwan
P.O.BOX: 375 Fengyuan, Taiwan.
+886-4-25248780 / +886-4-25225778
bottom of page